Justia Products Liability Opinion Summaries

A general contractor was hired to oversee the construction of a hotel in Vermont and subcontracted with a firm to install metal siding panels manufactured by a third party. The subcontractor relied on installation instructions available on the manufacturer’s website, which did not specify the use of a splice plate to connect the panels. The panels were installed without splice plates, and after construction, the panels began to detach from the building, causing some to fall and damage nearby property. The contractor later discovered that the manufacturer had created an instruction sheet in 2006 recommending splice plates, but this information was not publicly available at the time of installation.The contractor initially sued the installer for breach of contract, warranty, and negligence in the Vermont Superior Court, Chittenden Unit, Civil Division. The complaint was later amended to add a product liability claim against the manufacturer. After further discovery, the contractor sought to amend the complaint a third time to add new claims against the manufacturer, arguing that new evidence justified the amendment. The trial court denied this motion, citing undue delay and prejudice to the manufacturer, and granted summary judgment to the manufacturer on the product liability claim and on a crossclaim for implied indemnity brought by the installer, finding both barred by the economic-loss rule.On appeal, the Vermont Supreme Court affirmed the trial court’s decisions. The Court held that the trial court did not abuse its discretion in denying the third motion to amend due to undue delay and prejudice. It also held that the economic-loss rule barred the contractor’s product liability claim, as neither the “other-property” nor “special-relationship” exceptions applied. Finally, the Court found the contractor lacked standing to appeal the summary judgment on the installer’s implied indemnity claim. View "PeakCM, LLC v. Mountainview Metal Systems, LLC" on Justia Law